NETCAMM provides an immediate wire center view that shows the percentage of utilization by Distribution Area. Screenshot Any user can zoom into critical areas to examine facilities in greater detail. Those facilities may be cross connects, cables, terminals, etc. Screenshot NETCAMM provides the user the capability to hilite cable by percentage of fill and/or types of services. Screenshot Detail summaries on the cable characteristics, capacity, and utilization are provided. Screenshot Detail summaries on other facilities, such as cross connects are also provided. Screenshot Services are shown by user selected pair groups on all facilities. Screenshot Loop qualification can be done by identifying bridge taps in the network. Screenshot Facilities can be located by partial addresses and then the address required selected from a list. This will allow tracing of cable paths from the terminal to the central office. Screenshot NETCAMM provides for the placement of remote electronics for "what if" scenarios for cable fill relief. It provides for the recalculation of fills by complement groups based upon where the remote is placed. Screenshot Single-line feeder schematics can be generated automatically from the detailed facility information. Manhole Facility Details are imported from their non-geographical view to the geographical view to provide a continuous schematic. The schematic shows the cross section of cable summarized by fiber and copper gauges. Screenshot 1 | Screenshot 2 Additional databases can be integrated with the wirecenter view. Trouble reports can be imported and displayed. Queries can be performed to show trouble reports at a location, such as, trouble tickets on terminals. Screenshot Details of the trouble reports at a terminal can be displayed by point and click at that location. This example shows CRAS (Trouble Reports) tabs to see the detail. Screenshot